HOW TO INSTALL CERAMIC TILE.

If  this project is a wall & floor installation always start with the floor. 1.On bad concrete smooth with concrete filler, or similar compound. 2. On old concrete clean & remove old dirt, a degreaser is recommended. 3. On vinyl floor remove vinyl flooring and adhesives. 4. On wood floor install concrete board tape joints with fiber glass tape, & thinnest joints. 5. On old ceramic tile clean with degreaser and test a small area over night for bonding.

6. Draw your center lines and mark them with a chalk line, and a straight edge. 7. Layout a few tiles to visualize the layout. 8. spread your thinnest with appropriate trowel at a angle of 45degrees for mixing instructions refer to adhesive manufacturer. 9.Install the the ceramic tile, against the straight edge, and center line. 10. Lay a beating block on the tile & with a mallet pound gently to smooth the surface& to achieve better bond. 11. Move the straight edge to the next section of installation, & repeat step 8-11.

12. Remove wall paper   remove all traces of adhesives.    13. Remove loose paint and scratch good surfaces for better bonding. 14. Patch wall and  smooth  walls with appropriate  compounds. 15. Clean & wash old with TSP., or similar   degreaser cleaner. 16. Smooth ruff surfaces  by sanding or scrapping. 17. If installing over  old ceramic scratch the    glazed surface.

18. Draw your vertical line  using bubble level or tile setters lead. 19. Draw your horizontal line using a bubble level. 20. Spread adhesive at45 degrees follow manufacturer instruction.   21. Apply ceramic tile starting at the center to the side walls.  22. Proceed & cut the  side walls with nippers or a good tile cutter. 23. Cut the bottom as    much as required.

24. Clean the tile 24-36 hours after installation. 25. Spread grout a grout  flout. 26. With a grout  float pack grout into the joints. 27. Remove access grout with the grout float.   28. Let it dry for 10-20 Min.           29. Rub along the joints  with a wet sponge.

	TOOLS
30. Polish tiles with a clean cloth

.     

After grouting do not use or wet the area for 24 to 36 hours.

After 7 days from completion seal gout with a grout sealer.